Top Layer Problem
Hello
I have recently noticed that when I am printing the top layers do not go all the way to the edge, Please see the photo to see what I am talking about. I have tried to increases the top infill layer setting in Slic3r with not benefit.
https://www.dropbox.com/sh/mpqq4rijm1pnjy9/AAAnx6ao9CQtgZNZpqBXtLrga?dl=0
Thanks
Re: Top Layer Problem
Hi
You need to increase the loop/solid infill overlap. This is the setting in KISSlicer; I don't use Slic3r, so I can't tell you the setting name for that slicer, sorry.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Re: Top Layer Problem
Hello
At what value do you have your infill overlap?
Thanks
Re: Top Layer Problem
In KISSlicer, I have it set at 0.5.
There is a calibration for this. Please see the attached document.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…