[SOLVED] Bed not levelled
Hello everyone 😀 I have finally finish building my Prusa I3 MK2 which look beautifull and badass, but the printer don't want to be finished without any problem ^^ So firstly i had a problem with LCD -> Fixed, LCD Knob wheel -> Fixed, Z axis calibration -> Not fixed.
I used a bubble level to see if the bed is actually flat, but no :
And then i checked the threaded rod :
and no...
I don't know what to do :(, if you wan't, here is a short video of the Z calibration problem : Sorry if the camera shake a lot, i was pretty nervous at this moment 😐
If you wan't any extra info, tell me 🙂
Thanks 😉
Re: [Problem] Bed not levelled
Is the table leveled? 😉
It's absolutely not important to have the printer leveled by bubble level. Just keep the bed leveled related to the frame, not Earth.
Re: [Problem] Bed not levelled
Oh okay ! Thanks you very much, but i have another problem, with XYZ calibration, it says that a calibration point is too from p.i.n.d.a probe, i have change the height of probe, and i will send a video of the entire calibration. Thanks :))