Notifiche
Cancella tutti
Received Kit with 2 Left Z axis
Assembled my mk3s kit today and got all the way to wire routing before I noticed my "right" z axis didn't have long enough wires to make it to the control board. Flipped the printer on its side and sure enough both stepper motors say LEFT z axis. I contacted Prusa through there website, while I wait for them to remedy this can I extend the wires, or do the proper left and right z axis counter rotate.
Thanks!!!
Postato : 17/08/2019 1:07 am
RE: Received Kit with 2 Left Z axis
They rotate the same direction, and (I'm guessing) are identical except for the wire length and tag. Too bad it wasn't two right motors... lol.
Postato : 17/08/2019 5:29 am