[Fermé] Received Kit with 2 Left Z axis

Dernier message

RSS

lindersnow

(@lindersnow)

New Member

Received Kit with 2 Left Z axis

Assembled my mk3s kit today and got all the way to wire routing before I noticed my "right" z axis didn't have long enough wires to make it to the control board. Flipped the printer on its side and sure enough both stepper motors say LEFT z axis. I contacted Prusa through there website, while I wait for them to remedy this can I extend the wires, or do the proper left and right z axis counter rotate.

Thanks!!!

Publié : 17/08/2019 1:07 am

(@)

Illustrious Member

RE: Received Kit with 2 Left Z axis

They rotate the same direction, and (I'm guessing) are identical except for the wire length and tag. Too bad it wasn't two right motors... lol.

Publié : 17/08/2019 5:29 am

Statistiques du forum

565 Forums

63.7 K Sujets

446.5 K Messages

22 En-ligne

69.1 K Membres

Le dernier des messages: PrusaLink MAC not stable, local host name not allways working Notre nouveau membre: KaptainAhoibrause Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé