Notifications
Clear all

My MK2S first print, evaluate please, tx!  

  RSS
harri.v
(@harri-v)
Active Member
My MK2S first print, evaluate please, tx!

Hi,

just finished my assembly on MK2S and printed the PRUSA- logo. Calibrations all ok.

As a complete newbie to 3D printing, could someone evaluate the result? Is it tolerable or garbage? How to e.g. fintune the Z-level etc.

Thanks!

Napsal : 21/07/2017 9:42 pm
LaPointe
(@lapointe)
French moderator and translator Moderator
Re: My MK2S first print, evaluate please, tx!

Please read this post and its first 5 pages at least for the Z tuning: http://shop.prusa3d.com/forum/prusa-i3-kit-building-calibrating-first-print-main-f6/life-adjust-z-my-way-t2981.html
The right gcode file is the fourth version.

Napsal : 21/07/2017 10:17 pm
JeffJordan
(@jeffjordan)
Member Moderator
Re: My MK2S first print, evaluate please, tx!

anyhow: not bad for the first attempt !
how does the bottom of the prusa logo look like ?

dem inscheniör is' nix zu schwör...

Napsal : 21/07/2017 11:30 pm
harri.v
(@harri-v)
Active Member
Topic starter answered:
Re: My MK2S first print, evaluate please, tx!

Here is the bottom of the logo. Too much grooves?

Napsal : 22/07/2017 1:10 am
JeffJordan
(@jeffjordan)
Member Moderator
Re: My MK2S first print, evaluate please, tx!


Here is the bottom of the logo. Too much grooves?

IMG_3390.JPG

looks pretty good. with a little bit of fine tuning (Z live adjust), I think you can improve it a tiny bit, so that the grooves will "melt" together and you get a more unique surface. but that's a bit nitpicking at a high level.
I wish my first setup was as good as yours.... 🙄

last month I just posted a picture of the logo printed at my own printer here.

dem inscheniör is' nix zu schwör...

Napsal : 22/07/2017 9:12 am
Share: