Notifiche
Cancella tutti
Leaking
Hi!
I would need your help in optimizing my prints:
I have massive leaking from the nozzle with ABS (haven't tried with PLA so far). The nozzle temperature is set to 255 °C (I didn't change anything of the settings). What can I do to prevent that? Would reducing the nozzle temperature help?
Thank's for your help
Postato : 20/09/2015 12:04 pm
Re: Leaking
Hi, not the end of the world. You just forgot to tighten the nozzle as said in step 17 here http://manual.prusa3d.com/Guide/5.+Extruder/56#s972 🙂
Stop the print, clean up as much you can while hot and tighten the nozzle 🙂 💡
Founder and owner / Majitel a zakladatel
Postato : 20/09/2015 12:10 pm
Topic starter
answered:
Re: Leaking
Thank's a lot! I thought I did it, but apparently I needed brute force, a jaw spanner and an alligator wrench to tighten the nozzle 😀
Postato : 23/09/2015 10:52 pm
Re: Leaking
Glad to hear that! It's free workout bundled with every printer 😉
Founder and owner / Majitel a zakladatel
Postato : 24/09/2015 5:29 pm