Avisos
Vaciar todo

Leaking  

  RSS
georg.a
(@georg-a)
Active Member
Leaking

Hi!

I would need your help in optimizing my prints:
I have massive leaking from the nozzle with ABS (haven't tried with PLA so far). The nozzle temperature is set to 255 °C (I didn't change anything of the settings). What can I do to prevent that? Would reducing the nozzle temperature help?

Thank's for your help

Respondido : 20/09/2015 12:04 pm
Josef Průša
(@josef-prusa)
Miembro Admin
Re: Leaking

Hi, not the end of the world. You just forgot to tighten the nozzle as said in step 17 here http://manual.prusa3d.com/Guide/5.+Extruder/56#s972 🙂

Stop the print, clean up as much you can while hot and tighten the nozzle 🙂 💡

Founder and owner / Majitel a zakladatel
Respondido : 20/09/2015 12:10 pm
georg.a
(@georg-a)
Active Member
Topic starter answered:
Re: Leaking

Thank's a lot! I thought I did it, but apparently I needed brute force, a jaw spanner and an alligator wrench to tighten the nozzle 😀

Respondido : 23/09/2015 10:52 pm
Josef Průša
(@josef-prusa)
Miembro Admin
Re: Leaking

Glad to hear that! It's free workout bundled with every printer 😉

Founder and owner / Majitel a zakladatel
Respondido : 24/09/2015 5:29 pm
Compartir: