Avisos
Vaciar todo
How close should the nozzle be to the bed?
I don't know if it should be touching the glass or just off the glass. So any help would be great
Respondido : 22/06/2016 9:13 pm
Re: How close should the nozzle be to the bed?
Mitch
For the Mk1, the nozzle gap with standard firmware is 0.23mm (or very slightly less) when hot. First layers should be printed at 0.25mm
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Respondido : 22/06/2016 9:51 pm