A few related problems in print quality
Sorry, I don't have a better title. Long post ahead, sorry.
So I have my printer since mid February. Started to print suuuuuuper nice (but a bit of wobble on my first print, adalinda).
Anyhow, since a few days from here, I am getting a lot of problems. I asked support but well, I guess they have a lot of request, so I keep trying every day.
First it was just simple wobble:
New filament, so it could happen.
Then I tried the millenium Falcon
It failed hard at 60% or so.
Tried a different print
Super bad, you can feel those "bumps" with the finger.
I checked the bed belt, I put it again, reapply oil...
Tried to print a pot and the result...
Really really bad.
Printed that upper part like 20 times. I put the printer in the table, no foam in the middle. I even checked the frame, disassembled X, put belt again, oil... Nothing.
Then I discovered that I with more squish I could get somewhat better prints, but still not good
Wobble in this one:
Prusa contacted me, told me to check my blower (which doesn't work that well) but I tried abs:
Same result, no blower in here.
I checked that my leadscrew hits the orange piece on top (left one) in a certain range
Then when I tried to remove the abs thing, I noticed:
And well, I Tried to print something today and...
There is something really wrong.
