What's MK3 best overhang angle?
S3D default setting is 45, but has anyone printedPLA with shallower angles successfully?
Re: What's MK3 best overhang angle?
Janis
I have printed at 70 degrees from vertical without supports, but it does rather depend on the model and other settings (Loops before perimeters etc).
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Re: What's MK3 best overhang angle?
Slic3r has a unique "use bridging perimeters" feature, which extrudes thicker extrusion width on slopes, where the perimeters overlap less than 1/2 of their width. This allows one to print slopes as high as 70 degrees quite reliably.
Re: What's MK3 best overhang angle?
Many thanks!
Re: What's MK3 best overhang angle?
Damn, I have missed a release...
My new Mk2 hasn't been shipped yet, do you think I can get the order changed to a Mk3 ?
😀
Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK