Two colors, single extruder?

Dernier message

RSS

jere.s

(@jere-s)

New Member

Two colors, single extruder?

Hi!
Tried to search similar topic, no luck.

I have been using M600 command to make multi color prints.

I'd like to print small item, what has two different colors in same layer.
With M600 that cannot be done.

Can it be done some way? I know, there is lots of filament changes, but...

Thanks!

Publié : 09/09/2017 9:38 pm

AJS

(@ajs)

Noble Member

Re: Two colors, single extruder?

You can look at these threads for ideas:

http://shop.prusa3d.com/forum/print-tips-slic3r-settings-kisslicer-model-repair--f12/multi-color-printing-different-way-t4836.html

http://shop.prusa3d.com/forum/hall-of-fame-best-3d-prints-f15/-inlayed-magic-the-gathering®-card-box-and-separa-t5634.html

Please post what you figure out!

Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss. If you solve your problem, please post the solution…

Publié : 09/09/2017 10:12 pm

Statistiques du forum

559 Forums

62.8 K Sujets

442.5 K Messages

20 En-ligne

67.4 K Membres

Le dernier des messages: Minimum Z and E moves? Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé