Avisos
Vaciar todo
Stringy print when printing 0.05mm layers
Hi all,
I have been printing a lot and testing a lot with different brands of PLA. I dialed in most of the right extrusion multipliers for the different brands I use.
For example, I have a PLA for which I use a EM of 0.89 and prints come out great.
Except when I use the 0.05mm DETAIL MK3 preset. The print comes out all stringy and has a lot of rough edges.
What could be the cause of this?
I use the preset supplied in the 2.1.3 drivers.
Respondido : 14/01/2018 3:51 pm