Notifications
Clear all
Refilling filament during printing
It is a silly question, but how do I change filament when I am printing?
When I pause the print job then the extruder stays above the model. When I now want to unload the filament because it is running out of filament and load a new roll. Can I move the extruder somewhere else manually and when I resume it continues where it left off?
Opublikowany : 09/10/2016 1:51 am
Re: Refilling filament during printing
Press the LCD knob, select Tune/Change Filament
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Opublikowany : 09/10/2016 10:58 am
Topic starter
answered:
Re: Refilling filament during printing
Nice.
Opublikowany : 09/10/2016 4:08 pm