Notifications
Clear all
Maybe a problem at details
All in all I am very happy with my Prusa, but I need some input here.
Most prints I've done turned out pretty good so far, but on the latest I wondered if that kind of detail (or lack of) is normal or if there might be a problem with my settings or calibration.
I used simplify3d with the RC4 settings from this forum, on 0.1 detail settings with supports.
Any pointers are really appreciated.
Publié : 05/02/2017 8:35 pm
Re: Maybe a problem at details
you could try .050 layer, and using a smaller nozzle. these may improve the results.
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
Publié : 05/02/2017 9:55 pm
Topic starter
answered:
Re: Maybe a problem at details
Thanks, I'll give it a try!
Publié : 09/02/2017 11:52 pm