Avisos
Vaciar todo
Green-TEC Filament - Profile?
Hi fellow Makers,
I would love to try out the Green-TEC Filament ( https://www.filamentworld.de/shop/filament-3d-drucker/green-tec-filament-1-75-mm-blau/ ) but PR has no profile for it.
So my question is: What profile could i use as a base and then tweak around the temps etc to get good results ?
Does anybody have experience with it ?
Thanks
Respondido : 18/09/2016 11:22 am
Re: Green-TEC Filament - Profile?
Looking at the data sheet, the temperatures used look similar to PLA (a bit cooler than the default Prusa PLA, though). I would make a copy of the PLA profile, and start with that.
Respondido : 18/09/2016 11:28 pm