Notifiche
Cancella tutti
first layer is a little off
So my 1st layer seems to be a little off as shown in the photos. But it's not uniform. I printed this long object and it seems to be worse on one side than the other.
Besides doing a recalibration and live z-adjust what else could it be?
Postato : 15/12/2017 9:11 pm
Re: first layer is a little off
Please see these two threads:
Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss. If you solve your problem, please post the solution…
Postato : 17/12/2017 2:49 am