English
Forums
English forum
Original Prusa i3 MK3 & MK3S & MK3S+
Print tips (Archive)
first layer is a little off
 
Notifications
Clear all

first layer is a little off  

    Last Post
  RSS
Oggie
 Oggie
(@oggie)
Eminent Member
first layer is a little off

So my 1st layer seems to be a little off as shown in the photos. But it's not uniform. I printed this long object and it seems to be worse on one side than the other.

Besides doing a recalibration and live z-adjust what else could it be?

Posted : 15/12/2017 9:11 pm
AJS
 AJS
(@ajs)
Noble Member
Re: first layer is a little off

Please see these two threads:

http://shop.prusa3d.com/forum/prusa-i3-kit-building-calibrating-first-print-main-f6/-before-you-ask-troubleshooting-video-updated--t472.html#p39190

http://shop.prusa3d.com/forum/prusa-i3-kit-building-calibrating-first-print-main-f6/hyperfine-bed-leveling--t4330-s110.html#p41311

Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss. If you solve your problem, please post the solution…

Posted : 17/12/2017 2:49 am
  All forum topics
  Previous Topic
Next Topic  
Share: