Clear all

[Closed] Filament stopped extruding at certain layer  

Active Member
Filament stopped extruding at certain layer

Hello community, 

This never happen to my benchy but today I'm trying a new filament and it stops extruding from this layer. After some troubleshooting (cold pull with a nylon filament, vacuuming bondtech gear) I changed nozzle temp to 225℃ and it's now printing as normal. 

So issue is now fixed, but I wonder why filament would stop extruding before because the layer where it stopped is consistent. Not a huge issue as I have a workaround, but I want to learn. 🙂

Prusa i3 MK3S / Prusa Slicer / PEI sheet / Texture sheet / Satin sheet / design using Tinkercad

Posted : 15/07/2020 9:31 am