Filament sticking to nozzle, but only when printing skirt
 
Notifications
Clear all

Filament sticking to nozzle, but only when printing skirt  

  RSS
ir_fuel
(@ir_fuel)
Estimable Member
Filament sticking to nozzle, but only when printing skirt

I seem to consistently have this problem on my MK2sMMU. When printing (right now PETG) it extrudes the purge line just fine, then it goes to do the skirt, but when it starts extruding for the skirt it takes a couple of cm for it to stick to the build plate. In the mean time it just extrudes and balls up on the side of the nozzle, creating a lot of crap that gets dragged around and sticks at random places to my print.

What I don't understand is that I do not see that behaviour when it is printing the first layer, when it has to stop, move to another part, and start again. That's always perfect and nothing sticking to the nozzle. It also doesn't do this when printing the purge line. It only happens on the skirt.

Any idea?

Napsal : 03/03/2018 10:55 am
ir_fuel
(@ir_fuel)
Estimable Member
Topic starter answered:
Re: Filament sticking to nozzle, but only when printing skirt

Same problem with PLA btw

Napsal : 16/03/2018 10:52 am
Share: