Notifications
Clear all
Can I use a 2.85 mm filament in my Prusa i3?
Hello, I'm new here and this question may have been already asked. It's simple: Can I use a 2.85 mm filament in my Prusa i3 MK3S? If so, I'd have to change the PrusaSlicer parameters, wouldn't I? Thank you in advance.
Posted : 05/04/2020 5:35 pm
RE: Can I use a 2.85 mm filament in my Prusa i3?
you would need to change the extruder to one that would accept 2.85mm filament and you would need to configure the firmware to drive the extruder then you would need to set up slicr profiles to match the extruder.
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
Posted : 05/04/2020 5:49 pm
Topic starter
answered:
RE: Can I use a 2.85 mm filament in my Prusa i3?
@joantabb
Ok, thank you very much.
Posted : 05/04/2020 6:54 pm
Topic starter
answered:
RE: Can I use a 2.85 mm filament in my Prusa i3?
@joantabb
Ok, thank you very much.
Posted : 05/04/2020 6:55 pm