Notifications
Clear all
Bridging issues with nGen
Hi,
Has anyone had luck with bridging with the Prusa i3 Mk2 and ColorFabb's nGen filament? I have the problem that even with supports I have poor quality bridging - especially as Slic3r's support generation is so poor, and so hard to remove, and therefore something I don't like to use.
I've tried dropping the temperature as far as 225C on upper layers (which is low enough to cause flow issues) and the bridging fan up to 100%, but all to no avail. All other settings are left as the nGen profile from the Mk2 bundle.
Just wondered if anyone had any tips at all?
Attached is a photo of a bridging test, upside down.
Opublikowany : 02/03/2017 10:18 am