Notifiche
Cancella tutti

BIG MODEL PROBLEM  

  RSS
alessio.i
(@alessio-i)
New Member
BIG MODEL PROBLEM

hi, i'm having big problems printing this model. i printed it 50% smaller and it came out very good as photo.
now i need to print it 150% scale. I tried many sets and supports, brim and rafts. For some reason the model always "crash" in the same zone even if the adhesion seems good.

Thanks for any help or suggestions!

Alessio

Postato : 18/01/2017 7:01 pm
david.b14
(@david-b14)
Honorable Member
Re: BIG MODEL PROBLEM

I would play around with infill (go low) and the perimeter settings (go less).

Postato : 18/01/2017 8:04 pm
Condividi: