Notifications
Clear all

ABS + MK2 Kit  

  RSS
Yury
 Yury
(@yury)
Eminent Member
ABS + MK2 Kit

Dear,

With PLA i have no issues, everything is nice.

Just started to print with ABS, have to make go pro rig 360 from ABS fore sure.

I have printed PINDA cover from downloaded code - ok. (its a pity that there is no more code for ABS from PRUSA like in PLA 😳 ) just for test issues, MK1 had several but MK2 without ABS...

During print i have almost same issue with corners uplift

Printed 3 times with different infix and nearest seam position. Different temps with 100 and 105.
BRIM usually picks out after 4-6 layers...

Please help 😳

Posted : 14/09/2016 9:41 am
David T.
(@david-t)
Noble Member
Re: ABS + MK2 Kit

I would try less infill and different type (honeycomb). Too much linear infill increases forces causing warping.

Posted : 14/09/2016 10:29 am
Share: