How do I make flow 100% for first layer?

Dernier message

RSS

lucas.c3

(@lucas-c3)

Trusted Member

I been having to manually change flow to 100% from 95% at the start of every print. Where can I change this so its permanent? Thanks for help

Publié : 01/03/2018 1:41 am

Sendeva

(@sendeva)

Eminent Member

In slic3r you can change first layer width.
See manual http://manual.slic3r.org/expert-mode/extrusion-width

You might need to play with it to get to where you want.

Publié : 01/03/2018 2:16 am

Statistiques du forum

566 Forums

63.2 K Sujets

444.2 K Messages

21 En-ligne

68.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé