Does filament jam detection work ?
Nozzle clog happened and the printer printed in the mid air for my recent few prints.
Is MK3 supposed to have the function of detecting filament jam ?
Has anyone tested this function?
My filament sensor seems to be ok , at least autoloading of filament works for me.
Re: Does filament jam detection work ?
A nearly completely Yoda. I wanted to cry... if only the jam detection worked...
(I printed it on its back)
Re: Does filament jam detection work ?
my bondtech gear and I wasn't extruding but no error so I would say no, that said it was a clear natural pla. According to the manual lime green can cause problems with the sensor so maybe it was that
Re: Does filament jam detection work ?
IMG_0968.JPG
A nearly completely Yoda. I wanted to cry... if only the jam detection worked...
(I printed it on its back)
I have a 3d pen for cases like this. You could fill that last layer and then sand it to shape..
Re: Does filament jam detection work ?
IMG_0968.JPG
A nearly completely Yoda. I wanted to cry... if only the jam detection worked...
(I printed it on its back)
I have a 3d pen for cases like this. You could fill that last layer and then sand it to shape..
3d pen I have. May the force be with me...
Re: Does filament jam detection work ?
my bondtech gear and I wasn't extruding but no error so I would say no, that said it was a clear natural pla. According to the manual lime green can cause problems with the sensor so maybe it was that
Interesting....