Notifications
Clear all

Calibration Error  

Stránka 2 / 2
  RSS
themzlab
(@themzlab)
Estimable Member
Re: Calibration Error

I think the metal sheet is supposed to be on the printer for this part. Is it? Only is off for skew check and it prompts you.

Napsal : 30/12/2017 7:44 pm
michael.h33
(@michael-h33)
Active Member
Topic starter answered:
Re: Calibration Error

The directions say to take it off, but when its finding the 4 points, the nozzle is this high up, is this normal?

Napsal : 30/12/2017 10:29 pm
themzlab
(@themzlab)
Estimable Member
Re: Calibration Error

I did the full setup yesterday. Correct, during the skew check ( 4 corners) the head was suprisingly high maybe about 6 to 8 mm. And since it is sensing something in the pcb the build plate is off for this step. There were two rounds so 8 total stages.

Napsal : 31/12/2017 2:52 am
michael.h33
(@michael-h33)
Active Member
Topic starter answered:
Re: Calibration Error

Thanks everyone for your help I fixed it and now its printing perfectly

Napsal : 31/12/2017 8:06 pm
Stránka 2 / 2
Share: