Notifications
Clear all
What causes this type of print finish?
It seems like a decent print and could just be lighting and filament color but I feel as though I shouldnt be seeing these lines.
If I reduce extrusion I get gaps in small spots mainly infilled corners. Pid tuned and new heater core as well so temps should be stable. Prusament urban grey filament brand new spool out of the bag but did notice some stringing yesterday from ALL my filament that is stored correctly. Any advice is greatly welcome!
Posted : 26/01/2022 6:09 pm
Check your smooth rods are clean and lubricated, check your belt tension, make sure there is no debris clogging you idler pulleys.
Cheerio,
Posted : 26/01/2022 9:27 pm