Notifications
Clear all
Vase mode-> 4th layer is squeezed for some odd reason
Opublikowany : 02/06/2023 12:49 pm
RE: Vase mode-> 4th layer is squeezed for some odd reason
I wonder if there is an error in the mesh file causing this. It looks like the side is sloped to that point on the opposite side of your arrow.
Opublikowany : 04/06/2023 5:53 pm
RE:
The PrusaSlicer-Subforum might be a better place for this - anyway, posting the 3mf-file (you need to zip compress it for the forum to allow upload) will increase the probability of helping answers - although you did not actually ask anything...
This post was modified 2 years temu by Robin
If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!
Opublikowany : 10/06/2023 11:24 am