Notifiche
Cancella tutti
Ugly Line
Hey guys!
This is my first big print with my Prusa (love it Mk3S) but on the first picture i have this ugly line, i believe my nozzle isn't well calibrate?
Postato : 16/09/2019 1:24 pm
RE: Ugly Line
Not sure what it is you are seeing, everything looks normal. You have some small gaps with fill - perhaps a very small amount of under extrusion.
Have you calibrated and adjusted the flow multiplier and measured your filament and set the slicer accordingly? Either adjustment can cause the gaps.
Every thing else looks pretty good - and the model is quite nice; where is it from?
Postato : 16/09/2019 1:37 pm
Topic starter
answered:
RE: Ugly Line
ah maybe underextrusion, i'll check! It's fron printable scenery!
Postato : 16/09/2019 2:40 pm