Notifiche
Cancella tutti
TPU layer shift issue - Nijiflex Cheetah
Has anyone seen this? I have TPU now printing without clogging and getting good results as shown with the 3D Benchy, however when printing a tyre model getting a type of layer shift or distortion.
The first image is a full size print that had a misalignment early on.
The second is a 50% scale print with generic flex settings, all speeds to 15ms, no retraction and had another shift this time later on in the print.
Just to confirm the printer is mechanically OK I printed the tyre in PETG at normal speed and it was fine (orange image).
Prusa MK3+ using Nijiflex Cheetah with the following settings:
Nozzle: 240 Bed: 60/55
All speeds: 15ms
Retraction: None
Any help would be appreciated.
Postato : 15/06/2023 8:53 am