[Résolu] Top layer bulging outwards?

Dernier message

RSS

BulldogNine

(@bulldognine)

New Member

Top layer bulging outwards?

I am getting this bulge at the top layers (and slightly at the bottom layers above the first layer) when I begin printing PETG now. I believe this is occurring in the area where there is solid infill. I have adjusted my Live Z to what I believe is the correct distance and I lowered the Extrusion Multiplier to 0.95 which only moderately helped. Any thoughts on how to reduce or eliminate this issue?

Publié : 16/05/2021 12:19 am

(@)

Illustrious Member

RE: Top layer bulging outwards?

This is typical of a loose belt drive gear slipping on the motor shaft.

Publié : 16/05/2021 9:56 am

Statistiques du forum

565 Forums

63.6 K Sujets

446.3 K Messages

18 En-ligne

69 K Membres

Le dernier des messages: Mk4 Display Cable to short for the Prusa Original Enclosure? Notre nouveau membre: twh344 Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé