Seam  

RE: Seam

Set program on expert settings,

Go to  printer in the top of screen,

then layers and perimeters,

then on bottom of page seam.

RE: Seam

I can only move the seams posizion. Nozzle at the end of the layer re-enters, I believe so as not to make an accumulation of material on the surface. I wish the nozzle didn't re enters inside the layer.

RE: Seam

Posted by: maurizio.m6

I can only move the seams posizion. Nozzle at the end of the layer re-enters, I believe so as not to make an accumulation of material on the surface. I wish the nozzle didn't re enters inside the layer.

If you want to experiment, spend some time with KISSlicer. It offers an amazing array of z-seam hiding features. Unfortunately, it's very quirky to use and isn't under fast development. With PrusaSlicer, you can move the seam around but that's about it. You can calibrate your extrusion multiplier and Linear Advance settings to minimize the seam, but it will still be somewhere on each layer.

RE: Seam

S3D alows you to "use random start points for all perimeters" which does a good job of getting rid of seams, but it is not free.. 

RE: Seam

Posted by: gary.s4

S3D alows you to "use random start points for all perimeters" which does a good job of getting rid of seams, but it is not free.. 

All modern slicers do. The downside to random is that you often end up with zits all around the print.

RE: Seam

Random seams ...