Notifications
Clear all
Problem with bulging lower layers
I have problems printing a part where all prints come out with the first layers bulging outside the perimeter. I have tried elephant foot compensation, chamfers, but its always the second or third layers that extends outside the perimeter.
I have attached the Prusa Slicr 3mf file with the settings used for the prints below.
My first suspicion was temperature and/or cooling. I have experimented with settings that deviate from my normal PETG settings for the filament I use, AddNorth PETG. But the bulge is still there. I use Pursa Slicer 2.1.0+linux64.
Napsal : 02/06/2020 6:19 pm
Topic starter
answered:
RE: Problem with bulging lower layers
Retry adding slicer project file.
Still fails with "Filetype not allowed".
How do I add the .3mf file?
This post was modified před 4 years by Ernelli
Napsal : 02/06/2020 6:20 pm