Printing STL file made with Blender 2.8 - errors importing and size too small
 
Notifications
Clear all

Printing STL file made with Blender 2.8 - errors importing and size too small  

Strona 2 / 2
  RSS
Grumpster
(@grumpster)
New Member
RE: Printing STL file made with Blender 2.8 - errors importing and size too small

Wow, thanks so much!  That was exactly the help I needed.  Followed your advice, and created the exact test print I needed to try printing spare parts.  Now off to Makerspace to actually print it!

 

Opublikowany : 01/12/2021 8:18 pm
Grumpster
(@grumpster)
New Member
RE: Printing STL file made with Blender 2.8 - errors importing and size too small

...and it worked.  It scaled perfectly, printed exactly as per measurements...so green light to Blender>Prusa workflow!  (Huge)

Opublikowany : 01/12/2021 11:34 pm
Grumpster
(@grumpster)
New Member
RE: Printing STL file made with Blender 2.8 - errors importing and size too small

Hi, thanks again.  I thought I had successfully replied earlier, but didn't see it just now when I refreshed this page.

Your instructions were clear, correct, and effective.  Did a test print of a corner square and it printed at exact dimensions on my tape measure...Mission Accomplished!!  WOO and also HOO!!

 

Opublikowany : 02/12/2021 2:32 am
Neophyl polubić
Strona 2 / 2
Share: