Clear all

Cant figure out whats make this hard shift??  

Active Member
Cant figure out whats make this hard shift??

Last week, my MK3S+ was printing gorgeously. Then the repeated and dreaded MINTEMP Bed Error, so I replaced but the thermistor and power cables.
I did Z calibration, first layer calibration, Thermal calibration, etc and got these dreaded shifts. Bed belt and pulleys are secure, etc. Maybe a bearing? My slicer settings were golden pre thermistor replacement. I didnt change anything, but its the first time Ive replaced and messed with the bed/parts since getthing this machine directly from Prusa 4 years ago. I could use some insight.

Posted : 28/06/2023 8:04 pm