Notifiche
Cancella tutti
Printing hoverangs in a corkscrew conveyor
I'm trying to print the part below, and I get poor quality in the overhangs. The angle (45°) should not be an issue, but the edges do warp up during printing, this is very visible on the video. I'm printing in PLA.
Do you have any idea how I could improve this? I'm using 0.15mm layer height and 15% grid infill, besides this all parameters are default for Prusament PLA
Questa discussione è stata modificata 2 years fa 2 tempo da Galinette
Postato : 25/03/2023 10:00 pm