Avisos
Vaciar todo
Printing hoverangs in a corkscrew conveyor
I'm trying to print the part below, and I get poor quality in the overhangs. The angle (45°) should not be an issue, but the edges do warp up during printing, this is very visible on the video. I'm printing in PLA.
Do you have any idea how I could improve this? I'm using 0.15mm layer height and 15% grid infill, besides this all parameters are default for Prusament PLA
Este debate ha sido modificado el hace 2 years 2 veces por Galinette
Respondido : 25/03/2023 10:00 pm