Notifications
Clear all
Pillowing, but only on very last layer
Hey all,
I'm having this issue where the very last layer of my print is uglier than the ones below it.
The entire print looks good, but the very last one has these rough patches.
I printed this using Amazon Basic PETG.
I tried increasing fan speed, but I noticed the last layer already has fan speed at "104", so I don't think that is the issue.
I'm also not having the classical pillowing issues where the issue occurs on a lower layer, those all look fine.
Any ideas?
Color looks a bit weird on the image but is fine in IRL.
This topic was modified 3 years ago by GoMartijn300
Posted : 31/12/2021 11:49 am