Notifications
Clear all
PETG 'Candyfloss' or 'Cotton Candy'
When printing with Prusa PETG, I am seeing very fine stringing almost like candyfloss, (cotton candy?). Would anyone know what the cause might be?
I'm printing using the standard Prusa PET printer settings (Slic3r 1.41) but with the extruder temperature increased by 25 degrees. This has been done because my extruders temperature is consistently 25 degrees lower than its set point.
This topic was modified 6 years ago by Frostie
Posted : 24/05/2019 8:37 pm