Notifiche
Cancella tutti
PETG 'Candyfloss' or 'Cotton Candy'
When printing with Prusa PETG, I am seeing very fine stringing almost like candyfloss, (cotton candy?). Would anyone know what the cause might be?
I'm printing using the standard Prusa PET printer settings (Slic3r 1.41) but with the extruder temperature increased by 25 degrees. This has been done because my extruders temperature is consistently 25 degrees lower than its set point.
Questa discussione è stata modificata 6 years fa da Frostie
Postato : 24/05/2019 8:37 pm