pausing the print
Hi everyone,
is there some way to stop-pause the print at the selected point?
RE:
Yes. There is in PrusaSclicer.
If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!
RE: pausing the print
thanks 😊
RE:
Also check out https://blog.prusa3d.com/practical-uses-of-color-change-in-prusaslicer_59563/ for example uses.
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
RE: pausing the print
This note of mine was featured on '3D Printing Nerd' some time ago.
the attached file uses the code above inserted in the 'Custom Gcode>Pause Gcode' section to replace the M601 command that gives some people difficulties.
the file also includes a colourchange
Hope it helps,
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK