Notifications
Clear all

Half of the first layer is spreading out to much  

  RSS
Itworks Co
(@itworks-co)
Active Member
Half of the first layer is spreading out to much

Posted : 12/12/2022 9:07 pm
Itworks Co
(@itworks-co)
Active Member
Topic starter answered:
RE: Half of the first layer is spreading out to much

Looking at the first photo (Front) you can see his head had a lot of gaps between the lines

Looking at the second photo (Back) you are able to see that the lines go a little further down to his upper back but is no longer an issue once you get to the chest.

What setting do I need to change to get this more consistent?

Posted : 12/12/2022 9:12 pm
RandyM9
(@randym9)
Honorable Member
RE: Half of the first layer is spreading out to much

Your live Z needs to be adjusted closer to the print bed, or a larger negative number as you adjust it.

See this thread for a test print and instructions:

https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-assembly-and-first-prints-troubleshooting/life-adjust-z-my-way/

Cheers

Posted : 13/12/2022 4:58 am
Share: