Notifications
Clear all
Gap in print when using pause and resume
I finished assembling my MK3 on Monday, and today I had the first opportunity to try the "Pause print" function when changing filament. However, when I resumed the print, the printer didn't resume exactly where it had left off - it left a horizontal gap of approximately 1.6 mm in the layer, after which the printer resumed and continued perfectly. No crash was detected, and the layer wasn't shifted:
Is this a normal result of pausing and resuming a print? I stopped the print and then started over from the beginning, the gap did not occur again.
For reference, I'm running the 3.2.1-576 firmware, with Monoprice PLA. If I should provide any other information, please let me know.
Publié : 13/06/2018 9:01 pm