Notifiche
Cancella tutti

Fixing spiral vase bridges?  

  RSS
Delarado
(@delarado)
Trusted Member
Fixing spiral vase bridges?

Guys,

I designed and printed a pot in fusion360. I don't want to change the shape of it too much, if i can avoid it.  Are there any settings I can change to improve the way it prints? Some overhangs aren't great... See pics below...

Postato : 09/02/2021 9:41 pm
Honegod
(@honegod)
Active Member
RE: Fixing spiral vase bridges?

possibly decrease layer higth  to decrease the reletive thinness of the sloped wall ?

Postato : 10/02/2021 10:17 pm
Jerry
(@jerry-6)
Active Member
RE: Fixing spiral vase bridges?

Yes, for overhangs like that you'll need a shorter layer height. Might also help to increase the exterior perimeter extrusion width if you don't have a bigger nozzle to print with.

Postato : 11/02/2021 3:11 pm
Condividi: