Notifications
Clear all
First layer problem
Hello,
I am new to the 3D Printing world and I can't fix this. I am using the MK3S and Prusa PLA JetBlack.
Thank you for the help!
Publié : 08/07/2021 8:11 am
Topic starter
answered:
RE: First layer problem
Now its finished and it looks like this.
Publié : 08/07/2021 8:18 am
RE: First layer problem
looks like you have the basics down. Since only one section is lifting, I'm going to guess you have fingerprint oils on your print bed. Clean it well with dish soap and hot water, dry with paper towels and handle only by the edges. Enable 7x7 bed mesh leveling in the control panel settings.
Publié : 08/07/2021 12:43 pm