Benachrichtigungen
Alles löschen

First Layer Issues  

  RSS
michael.n27
(@michael-n27)
Active Member
First Layer Issues

I have been able to get many successful prints and all of a sudden this started happening. I'm still relatively new, so not sure what to do. I have recalibrated and everything seemed ok. So I'm at a loss.

Veröffentlicht : 22/01/2020 5:54 pm
rmm200
(@rmm200)
Noble Member
RE: First Layer Issues

Start here:

https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-assembly-and-first-prints-troubleshooting/life-adjust-z-my-way/

Print a 2" or so calibration square or circle. Adjust Z while it is printing until you get a solid layer - not separate strands.

Post a picture here so we can see how it looks.

Veröffentlicht : 22/01/2020 7:39 pm
Teilen: