RE: Excommunicado
All that was done in P.Slicer. Well, that and a quick coat of paints. Had I looked at more stamps before working on it, I'd have used a thicker base for the stamp; mine is a bit thin as created above.
RE: Excommunicado
It's a 3mf working file. You should be able to exchange just the stamp layer with the excomm image and keep the rest intact. If not, add the excomm and bury the sanction stamp inside the parts.
RE: Excommunicado
@tim-m30
Pardon me for my continued noobish inquiries but how would one go about swapping out one image for another? I tried this in Prusa slicer and couldn't figure it out. When I tried to add the cut excommunicado image as a part to the stamp it made the whole surface blank. Thank you.
RE: Excommunicado
Make sure you have Object selected (lower left) and not Preview
RE: Excommunicado
It's select the top name in the parts list, then click Add part / Load... then select the file you want to add to the stack.
But the new stamp had some issues to resolve ...
RE: Excommunicado
Played some more - this iteration stamp is gcode only for now, stl is way huge to post at 600m -- the surface was a bit rough and I think I clicked the subdivision button about 10 times too many. But the gcode is only 20m.
This is the Excommunicado stamp, with turned handle, 75 mm diameter. Looks and feels better in the hand than prior versions. Requires some finishing to smooth/remove warts (artifact of print layer height.