Debris fall on the bed, stringing after changing nozzle 0.4>0.6 mm
 
Notifications
Clear all

[Résolu] Debris fall on the bed, stringing after changing nozzle 0.4>0.6 mm  

  RSS
Alk
 Alk
(@alk)
New Member
Debris fall on the bed, stringing after changing nozzle 0.4>0.6 mm

Hi everyone, 

I started to experienced nozzle swapping lately to 0.6mm nozzle and i can't make it run nicely. 

I have some blob falling on the print bed, sometime falling aside the print, sometime messing with the print and creating collision error.

Settings and check : 
- change my prusa profile to mk3s 0.6 mm nozzle 
- checked if the nozzle was well tighten (it is) 

What i've tested : 
- two materials : pla and petg --> same behavior 
- increasing Temp --> no change in behavior
- changing slicer --> same behavior 
- change model to print --> same behavior 

Maybe i need to change some settings but i thought that this would do with prusa presets.
Does someone experienced same trouble ? Do you have any suggestions ?
Thanks by advance !

 

Ce sujet a été modifié il y a 3 years par Alk
Publié : 27/11/2020 1:09 pm
Alk
 Alk
(@alk)
New Member
Topic starter answered:
RE: Debris fall on the bed, stringing after changing nozzle 0.4>0.6 mm

Aucune description de photo disponible.
it was indeed a problem of leaking, my heating block was loose and I tightened too much the nozzle. After a little cleaning, all run perfectly.

Publié : 28/11/2020 2:56 pm
Partager :