Notifiche
Cancella tutti
Bubbling / raising on petg bottom layer
Hi There
I am thinking that either my bed temp is too hot or my z axis is too low but I get these splits and bubbles in my bottom layer. What do I tune to get rid of this?
It's PETG and i'm running a 90 degree bed temp.
Questa discussione è stata modificata 4 years fa da Infiltrator
Postato : 12/10/2020 6:07 am
RE: Bubbling / raising on petg bottom layer
That's bed contamination.
Postato : 12/10/2020 6:19 am