Benachrichtigungen
Alles löschen
All kinds of mess
After reading many many posts I've decided to submit some pictures of my own.
What I have done:
- New nozzle.
- Cleaned print bed in all of the ways posted.
- First layer calibration seems fine, per all documentation.
- Tried adjusting the Z offset slightly lower and higher to see if has any affect.
- have heated, dehydrated, preheated the filament.
- put the entire 3d printer into a dry wooden box to maintain even temps.
What I observe:
- some burnt looking sections on the prints.
- curling at the back corners where the print comes up from the print surface.
- stringing of the filament off the top end of the print.
- Usually I can't get through an entire print before the whole print job fuses itself to the nozzle and drags around for an hour.
I would really appreciate some tips.
Veröffentlicht : 07/12/2022 8:17 pm